After I came back from a long vacation, I found that my Tonidoplug2 was off and then I replug the power cord to ensure it was fit tightly. But after several attempts, it was no luck to boot the device and the LED never light up.
I tried to take the HD out and connect it directly to a PC. The HD worked perfectly but I still cant boot the device either with or without the HD plugged.
I still cant figure out the issue til now. I would appreciate if you guide could give me some suggestion.
Many thanks!
Plug 2 does not work and led light goes off
Re: Plug 2 does not work and led light goes off
Did you have the rootfs on the external harddisk?
If yes, you can run a fsck on the disk.
If yes, you can run a fsck on the disk.
Re: Plug 2 does not work and led light goes off
Thank you for the suggestion but I doubted this is the problem of the harddisk. Actually I mean my Tonidoplug was like without power even with the power cord connected, is it possible that the detachable AC plug or some circuit inside the Tonidoplug was burnt?
Re: Plug 2 does not work and led light goes off
That is possible. If you had a power surge when you were away, then it might have burnt the power circuit. There are some online instructions on howto change power source for sheeva plug https://www.newit.co.uk/shop/resources/SheevaPlug-Howtoreplace.pdf. You may be able to try and replace yours following these lines.
Return to “TonidoPlug Support”
Who is online
Users browsing this forum: No registered users and 7 guests